Adjusting The Sensor On The Stacker Clamp - Pfaff 3519-4/01 Instruction Manual

Adjustment
13

Adjusting the sensor on the stacker clamp

.21
●
●
●
●
●
●
108
Requirement
1. LED 2 should light up, if there is no material between sensor 3 and refl ector 4.
2. LED 5 should light up, if there is material between sensor 3 and refl ector 4.
Fig. 13 - 42
Press down key 1 for approx. 5 seconds until LED 2 fl ashes quickly.
After key 1 has been released, sensor 3 begins with the learning process "no material" .
To set off the learning process "material" , place a piece of think white material directly un-
der refl ector 4.
Confi rm by pressing key
Press key 1 again within 5 seconds. The starting function changes from the set-up
"bright" (standard) to "dark" .
Carry out a function control in accordance with requirements
1.
4
3
1
2 5
1 and 2.