Adjusting The Work Clamp Pressure; Inserting And Removing The Sd-Memory Card - Pfaff 3119 Instruction Manual

Setting up
9

Adjusting the work clamp pressure

.09
9

Inserting and removing the SD-memory card

.10
40
1
Fig. 9 - 07
Fig. 9 - 08
By moving slide 3 it is possible to activate (position "LOCK") or deactivate
the write protection function of the SD-memory card. To store, process or
delete data on the SD-memory card, the write protection function must be
deactivated.
●
Inserting the SD-memory card
●
1
●
●
2
Removing the SD-memory card
●
●
●
3
Adjust the work clamp pressure by tur-
ning adjustment screw 1.
The sewing pressure depends
on the material of the workpi-
ece and must be adapted to
this. It is set correctly when the
workpiece is fed reliably and
shows no feed marks.
Open cover 1.
Insert SD-memory card
slot with the label at the front.
Close cover 1 again.
Open cover 1.
Press the edge of the SD-memory card
lightly – the SD-card is ejected.
Close cover 1 again.
2 into the card
2