Table of Contents
Advertisement
12
Care and maintenance
12
Maintenance intervals
.01
Clean the entire machine ..................................................................................once a week
Clean the needle area ............................................................................. several times daily
Clean the hook area ................................................................................ several times daily
Clean the fan air fi lter .......................................................................................... as required
Clean the air fi lter ................................................................................................ as required
Check the air pressure ................................................................. daily, before each start up
Check the oil level ........................................................................ daily, before each start up
Lubricate the cutting device ......................................................... daily, before each start up
Lubricate the stacker drive ...........................................................................every 6 months
12
Cleaning the entire machine
.02
The cleaning cycle required for the machine depends on following factors:
●
Single or several shift operation
●
Amount of dust resulting from the workpiece
It is therefore only possible to stipulate the best possible cleaning instructions for each indi-
vidual case.
●
Clean the entire machine at least once a week.
During all cleaning work the machine must be disconnected from the power
supply by switching off the main switch or pulling out the plug!
Danger of injury if the machine is started accidentally!
Disconnect the machine from the electric circuit by switching it off with the
on/off switch or by pulling out the mains switch!
Danger of injury if the machine is started unintentionally.
Care and maintenance
59
Advertisement
Table of Contents
