13
Adjusting the short brushes
.15.02
Requirement
1.
When the brushes are closed, the top and the bottom brush should just be resting on
or touching on the loading table.
2.
When the brushes are open, the top and the bottom brush should each have a dis-
tance of approx. 4 mm to the loading table.
3
4
6
Fig. 13 - 33
Adjusting the top brushes:
●
Turn screw
●
Turn screw
Adjusting the bottom brushes:
●
Adjust cylinder holder
●
Turn screw
1
2
5
1 (nut 2) in accordance with requirement 1.
3 (nut 4) in accordance with requirement 2.
5 (nut 6) in accordance with requirement 1.
7 (nut 8) in accordance with requirement 2.
How far the brushes 1 close depends on the material and must be corrected in
accordance with the sewing result.
Adjustment
7
8
99