Connect The Card To The Computer - Eaton Power Xpert Gateway Minislot Quick Start Instructions

Connect the Card to the Computer

C C o o n n n n e e c c t t t t h h e e C C a a r r d d t t o o t t h h e e C C o o m m p p u u t t e e r r
To connect the card to the computer:
1. Plug the small connector at the end of the supplied USB configuration cable into the setup port on the card
(see Figure
Figure 3. Install the USB Cable
2. Plug the other end of the USB cable into the USB port on the computer. The Windows operating system
detects new hardware.
NOTE
NOTE
3. Connect an active Ethernet cable (not supplied) to the Ethernet 10/100 connector on the PXGMS card (see
Figure
4 Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
3).
If a message indicates that the device driver software was not successfully installed,
click Ignore.
You may see a pop-up message window that shows "Found new hardware." This
indicates that the hardware installed successfully.
4).