Table of Contents
Advertisement
•
For firmware versions older than 2.6.5 the default username and password is "admin".
The PXGMS card Web page displays.
NOTE
If the system is unresponsive and you cannot make any selections, the browser may be
running in compatibility mode. To disable compatibility mode, go to the
Enable Browser Compatibility Mode
3.
Select Network from the Configuration menu. The Network page displays (see
Figure 9. PXGMS Card Network Page
4.
Under IPv4, the Automatic Configuration: DHCP Enabled setting checkbox should be enabled by
default. Make sure the checkbox is checked (enabled) before continuing.
5.
Scroll down to Name Service and expand the selection to update the next two DHCP settings (see
Figure
10):
•
Check the checkbox (enable) for Use DHCP (when enabled) to get name services.
•
Check the checkbox (enable) for Use DHCP (when enabled) to get domain name.
6.
Click Apply.
section.
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
Obtain a DHCP-Assigned IP Address
Figure
9).
9
Advertisement
Table of Contents
