Table of Contents
Advertisement
Assign an IP Address Manually
Figure 11. Disable DHCP Setting
4.
Uncheck the DHCP Enabled checkbox to disable DHCP and allow you to manually configure the IP
address (see
5.
Refer to the
IPv4 > Manual Configuration section.
6.
Click Apply, then click OK to confirm.
7.
Optional: If you are using a host name, or host names, for controlling access to the card:
•
Type the server IP address in the Name Server box. (Up to three IP addresses can be entered.)
•
Click Apply. Click OK to confirm.
8.
Open a browser and enter the fixed (static) IP address.
9.
Log on as administrator:
•
For firmware 2.6.5 and higher the username is "admin" and the default password is the card's MAC
address (case sensitive with no colons).
For example: Card's MAC address: 00:E0:D8:FF:C0:C4
12
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
Figure
11).
Installation Checklist
section. Enter the IP address, Netmask, and Gateway addresses in the
Advertisement
Table of Contents
