Table of Contents
Advertisement
Obtain a DHCP-Assigned IP Address
Figure 10. Name Services Settings
7.
Select Yes for the message, "Do you want to save the Network Configuration?"
8.
Wait for approximately two minutes for the card to reboot. Initially, all lights will be lit. You will know the
card has finished rebooting when only the top light (Status) and the bottom light (Power) remain lit.
9.
Open a browser and enter the default IP address (https://169.254.0.101 for firmware 2.6.0 or later,
http://192.168.200.101 for earlier firmware versions).
10. When prompted, log on as administrator:
•
For firmware 2.6.5 and higher the username is "admin" and the default password is the card's MAC
address (case sensitive with no colons).
For example: Card's MAC address: 00:E0:D8:FF:C0:C4
–
–
•
For firmware versions older than 2.6.5 the default username and password is "admin".
The PXGMS card Web page displays.
11. Click Network in the menu list.
12. Does the DHCP-assigned IP address display?
•
If yes, uncheck (disable) the DHCP Enabled box and select Apply.
10
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
Administrator name: admin
Password: 00E0D8FFC0C4
Advertisement
Table of Contents
