Table of Contents
Advertisement
Register a PredictPulse Subscription
16. Upload the .rom file to your connectivity card. The update can take up to 15 minutes. If the page does not
automatically refresh after 15 minutes, manually refresh the page.
NOTE
C C o o n n f f i i g g u u r r i i n n g g t t h h e e C C o o n n n n e e c c t t i i v v i i t t y y C C a a r r d d f f o o r r P P r r e e d d i i c c t t P P u u l l s s e e
To configure the Connectivity Card:
1.
Select E-Mail from the Configuration menu (bottom left). The E-Mail page displays (see
Figure 17. PredictPulse Configuration E-Mail
2.
Verify that the SMTP server IP/hostname name is correct. Note that mail.etn.com shown in Figure 18 is
only an example; the site SMTP server IP/hostname should be used (for the wireless modem/router use
mail.eaton.com).
3.
Click Test SMTP server connection. A new browser window or tab opens displaying the test results (see
Figure
window or tab.
Figure 18. E-mail Connection Test
If the results are unsuccessful, verify the Network settings from the Configuration menu.
16
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
If an error message is received after attempting the upgrade, reboot the card before
attempting the upgrade again; see
Configuring the Connectivity Card for PredictPulse
18). At the bottom of the results, verify "Email successfully sent..." is displayed, then close the
Step 9
of the
section for reboot instructions.
Figure
17).
Advertisement
Table of Contents
