Table of Contents
Advertisement
Obtain a DHCP-Assigned IP Address
Figure 8. Update Driver Software Window – Update Successful
9.
Click Close.
10. Either obtain the DHCP-assigned IP address or manually enter a fixed IP address:
•
To obtain the IP address assigned through DHCP, continue to the
section.
•
To manually enter a static (fixed) IP address for the card's network connection, go to the
Assign an IP Address Manually
NOTE
O O b b t t a a i i n n a a D D H H C C P P - - A A s s s s i i g g n n e e d d I I P P A A d d d d r r e e s s s s
NOTE
To obtain the IP address through DHCP:
1.
Ensure the PXGMS card is still connected to the computer over the USB cable. Also ensure that the
network cable is connected from the PXGMS card Ethernet port to the network connection.
2.
If your Web browser already open to the default IP address, go to step 3. Otherwise, perform the
following:
a.
Open your Web browser.
b.
Enter: https://169.254.0.101 for firmware 2.6.0 or later, http://192.168.200.101 for earlier firmware
versions.
c.
Log on as administrator.
•
8
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
section.
By default, the PXGMS card requests an IP address through DHCP when connected to a
network.
If connecting PredictPulse via an Eaton wireless modem, refer to the document
Connecting a NetComm Wireless NTC-140W Series Router to an Eaton Network Card
rather than this section.
For firmware 2.6.5 and higher the username is "admin" and the default password is the card's
MAC address (case sensitive with no colons).
For example: Card's MAC address: 00:E0:D8:FF:C0:C4
–
Administrator name: admin
–
Password: 00E0D8FFC0C4
Obtain a DHCP-Assigned IP Address
Advertisement
Table of Contents
