Table of Contents
Advertisement
NOTE
•
If no, go to the
PXGMS card.
NOTE
A A s s s s i i g g n n a a n n I I P P A A d d d d r r e e s s s s M M a a n n u u a a l l l l y y
NOTE
To manually enter a static (fixed) IP address for the card:
1.
Ensure the PXGMS card is still connected over the USB cable and the network cable is connected from the
PXGMS card Ethernet port to the network connection.
2.
If your Web browser already open, go to step 3. Otherwise, perform the following:
a.
Open your Web browser.
b.
Enter: https://169.254.0.101 for firmware 2.6.0 or later, http://192.168.200.101 for earlier firmware
versions.
c.
Log on as administrator.
•
•
The PXGMS card Web page displays.
3.
Select Network from the Configuration menu. The Network page displays (see
At this point, the DHCP address is saved as a static IP address.
Assign an IP Address Manually
For detailed information, refer to the
Eaton Power Xpert Gateway Minislot PXGMS UPS Card User's
If connecting PredictPulse via an Eaton wireless modem, refer to the document
Connecting a NetComm Wireless NTC-140W Series Router to an Eaton Network Card
rather than this section.
For firmware 2.6.5 and higher the username is "admin" and the default password is the card's
MAC address (case sensitive with no colons).
For example: Card's MAC address: 00:E0:D8:FF:C0:C4
–
Administrator name: admin
–
Password: 00E0D8FFC0C4
For firmware versions older than 2.6.5 the default username and password is "admin".
section to manually obtain a static IP address for the
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
Assign an IP Address Manually
Guide.
Figure
11).
11
Advertisement
Table of Contents
