Hot-Water Spout Removal; Figure 001-53: Front Trim Piece Screws - Miele CM6 Technical Information

CM6
Warning!
When re-installing: In order to avoid possible water system faults (e.g.,
clogging or blocking of valves), grease, oil or other slip lubricants should
never be used when assembling and installing water system parts.
4.25

Hot-Water Spout Removal

1. Remove the top cover; see Section 001-4.5.
2. Remove the front panel; see Section 001-4.8.
3. Remove the two T10 screws securing the front trim piece (listed as "front facing" in
ETD); see circles, Figure 001-53. Take off this trim piece.

Figure 001-53: Front Trim Piece Screws

4. Pull the chrome sleeve off of the hot-water spout (Figure 001-54, Item 1).
5. Disconnect the hose from the spout (spring clip) (Figure 001-54, Item 2).
6. Remove the T10 screw securing the hot-water spout mounting bracket (Figure
001-54, Item 3).
7. Using a small flathead screwdriver, lever off the spout mounting bracket from the
underside of the spout assembly.
8. Pull the spout down and out of the appliance.
Technical Information
61