Brew Unit Present Switch (S87-2) Removal; Grind Amount Step Contact Switch (S51-4) Removal; Dispenser Assembly, Spout Present Switch (S87-6) Removal; Figure 001-50: Brew Unit Drive Position Switches - Miele CM6 Technical Information

CM6
8. Disconnect the electrical connections from the brew unit drive position switches
(Figure 001-50, Item 2) and release the switches from the brew unit drive
assembly.
9. Remove the last two T10 screws securing the brew unit drive (Figure 001-50, Item 1).

Figure 001-50: Brew Unit Drive Position Switches

10. Remove the brew unit drive assembly from the appliance.
11. Disconnect the electrical connections from the brew unit present switch and grind
amount compensation switch. Release these switches from the brew unit drive.
4.22

Brew Unit Present Switch (S87-2) Removal

See Section 001-4.21.
4.23

Grind Amount Step Contact Switch (S51-4) Removal

See Section 001-4.21.
4.24

Dispenser Assembly, Spout Present Switch (S87-6) Removal

1. Remove the top cover; see Section 001-4.5.
2. Remove the front panel; see Section 001-4.8.
3. Remove the two T10 screws securing the top of the dispenser assembly to the
inside of the appliance.
4. Take off the stainless-steel dispenser cover.
5. Unsnap the spout assembly from the dispenser assembly.
6. Remove the two T10 screws securing the top of the hose cover and the two T10
screws securing the bottom of the hose cover to the dispenser assembly. See
circles, Figure 001-51. Take off the hose cover.
Technical Information
59