Technical Information
2. To ensure that the ground quantity compensation can set correctly, reset the
appliance to standard settings; see Section 001-4.3.
3.25
Water Pump Does Not Pump
The water pump does not pump any water.
Cause:
Appliance has stood for too long. Water pump has run dry.
Remedy:
1. Remove the water tank.
2. Push the pressure pump (mat. no. 07994080) together and fill it with
water. See Figure 001-19.
3. Insert the full pressure pump into the water tank receptacle.
4. Activate the water pump in service mode (see Section 001-4.4) and use it
to push water through the system.
4
Service
4.1
Drink Settings (Customer Programming)
Initial requirements:
1. Switch the appliance on.
2. Let the appliance heat up.
Accessing:
Press the
Acknowledgement indicator:
Parameters is displayed.
Options:
Note:
If a selection is not made within 15 seconds, the appliance will
automatically go back one menu level.
1. Press the
2. Press the OK touchpad.
3. Press the
touchpad.
or
touchpad until the desired setting is marked.
or
touchpad until the desired drink is marked.
32
CM6