Table of Contents
Advertisement
CM6
Function
Software version
Fault memory
Component (press
OK to start or stop
activation)
Options
EPB
e.g., ID 03032 V5
EPL
e.g., ID 03031 V4
LNG
e.g., 5074
OK
Delete
Cancel
Delete
On
Lighting 1H3 + 2H3
(CM 63x0 only)
Off
Initialize
Step counterclockwise
Step clockwise
Continuous counterclockwise Ceramic valve is moved
Continuous clockwise
1
Ceramic valve M29
Position 1
Position 2
Position 3
Position 4
Position 5
Position 6
Position 7
Position 8
Initialize
Continuously upward
2
Brew unit M26
Continuously
downward
Home position
Drainage position
Compressing position
On
Grinder M25
Off
Phase chopping
Pulse package
Pump M7
Continuously
4
Emptying system
5
R1 (heater)
39
Technical Information
Description
Display/control
electronic EPB (N1-2) ID
number and version
Power electronic EPL (1N1-1,
2N1-1) ID number and version
N/A
All logged faults are shown
(F0000 = no faults).
Fault memory is not deleted.
Fault memory is deleted.
Lighting is switched on and off.
Ceramic valve is moved
through all positions.
Ceramic valve is moved
counterclockwise.
Ceramic valve is moved
clockwise.
continuously counterclockwise.
Ceramic valve is moved
continuously clockwise.
Not used
Ventilation, hot water
Hot water, steam, air
Steam, air open (milk froth)
Steam (hot milk)
Reference, closed
Coffee, decompression, pause
Rinse, air
Brew unit moves through all of
its positions and then back to
the home position.
The brew unit is advanced to
the top end setting.
The brew unit is advanced to
the bottom end setting.
Brew unit moves to the
appropriate position.
Grinder is switched on.
Grinder is switched off.
3
B3/4 ***
1/s
3
B3/4 ***
1/s
3
***
1/s. Pump is activated
continuously.
Empty the water tank or
remove it from the appliance.
Press the OK touchpad.
Press OK. R30-14 (heater
NTC) temperature is displayed.
Activate: Press OK. If the
NTC temperature increases,
the heater is in order.
Deactivate: Press OK again.
Advertisement
Table of Contents
