Installation : Forward-Facing
Lower Universal Anchorage System (LUAS) Installation
•
Figure A illustrates a typical forward-facing LUAS
installation.
•
Verify that your vehicle is equipped with LUAS
anchors. If LUAS anchors are not available, you must
use vehicle belt installation methods.
WARNING!
•
This child seat must not
for children less than one year of age OR who weigh
less than 9.1 kg (20 lbs).
•
This child seat must be in the upright position when
installed forward-facing.
•
Always use the Versa-Tether when the child seat is
installed forward-facing. Check your vehicle owner's
manual for approved tether anchor locations.
1
Remove the LCS connectors from storage slots
under the cover. See page 29. Pull both LCS
connectors completely through the child seat's
right-side, rear-facing belt slot (Fig. B) so they are
on the outside of the shell.
NOTE: The child seat is assembled with LCS
connectors in rear-facing mode.
2
Press and hold one LCS adjuster release button,
then pull to extend LCS strap to full length. Repeat on the other end
of the strap.
3
Thread the appropriate LCS connector through forward-facing belt
path (Fig. C) at the back of the child seat.
4
Place the child seat sideways in the upright position on the vehicle seat
with the back of the child seat facing you.
5
Remove the Versa-Tether from the pouch and place it up and over the
child seat back.
18
be used forward-facing
A
Forward-Facing
b
C