Table of Contents
Advertisement
Installation : Forward-Facing
Lap-Shoulder Belt Installation
•
Figure A illustrates a typical forward-facing lap-
shoulder belt installation.
•
When not in use, always store the LCS connectors in
storage slots. See page 29.
WARNING!
•
This child seat must not be used forward-facing
for children less than one year of age OR who
weigh less than 9.1 kg (20 lbs).
•
This child seat must be in the upright position
when installed forward-facing.
•
Always use the Versa-Tether when the child
seat is installed forward-facing. Check your
vehicle owner's manual for approved tether
anchor locations.
1
Place the child seat forward-facing on the vehicle
seat. Ensure the bottom of the child seat base is in
full contact with the vehicle seat.
2
Remove the Versa-Tether from the pouch and
place it up and over the child seat back.
3
Rotate the lock-off lever to open the forward-
facing lock-off farthest from where the vehicle
belt will be buckled.
4
Pull the vehicle belt out, then pass it through the
forward-facing belt path (Fig. B) to the opposite
side of the child seat.
5
Verify that the vehicle belt is not twisted and then
buckle (Fig. C).
6
Push the child seat firmly into the vehicle seat
while removing slack first from the lap portion of
the vehicle belt, then from the shoulder portion (Fig. D).
20
A
Forward-Facing
b
C
D
Advertisement
Table of Contents
