Table of Contents
Advertisement
Installation : Versa-Tether
Using the Versa-Tether
1
Consult your vehicle owner's manual for
designated tether anchorage locations.
2
Locate the tether on the rear of the child
seat and remove the tether from the
pouch.
3
Place the tether up and over the child seat
back.
4
Install the child seat using the LUAS or the
vehicle belts according to the instructions
in this manual.
5
Tilt the tether release tab then pull the
tether strap to fully extend it into a "V"
shape.
6
Locate the hook on the strap and loosely
attach the tether to the vehicle's designated
tether anchor.
•
See figure A for a forward-facing installation.
•
See figures B and C for a rear-facing
installation.
7
Pull the tether adjuster strap to remove all
slack. Roll up any excess webbing and store
in tether pouch.
8
Verify there is tension in the tether strap
and that the child seat is properly secured.
•
The child seat is secure when it cannot be
moved front-to-back or side-to-side more
than 2.5 cm (1 in.) at the belt path.
26
OR
A
OR
b
C
Advertisement
Table of Contents
