Table of Contents
Advertisement
Installation : Rear-facing
Lap-Belt Installation
•
Figure A illustrates a typical rear-facing, lap-belt
installation.
•
When not in use, always store the LCS connectors in
storage slots. See page 29.
1
Recline the child seat and place it rear-facing on
the vehicle seat.
WARNING!
recline position when installed rear-facing. See
Recline Adjustment on page 29.
2
Lift the child seat cover and open the rear-facing
lock-off farthest from where the vehicle belt will
be buckled (Fig. B).
3
Pull the vehicle belt out then pass it through the
rear-facing belt slot (Fig. C).
•
The vehicle belt can be routed over or under the
child seat cover.
4
Route the vehicle belt across the child seat then
through the opposite rear-facing belt slot.
•
The vehicle belt must rest behind the child seat
buckle strap.
5
Verify that the vehicle belt is not twisted, position
the belt through the open lock-off, then buckle
(Fig. D).
6
Push the child seat firmly into the vehicle seat
while removing the slack from the vehicle belt.
7
Tighten the belt, close the lock-off arm (Fig. E)
and replace the cover.
•
The lock-off is properly closed when a positive click
is heard.
16
This child seat must be in the
A
Rear-Facing
b
C
D
Advertisement
Table of Contents
