Table of Contents
Advertisement
Installation : Forward-Facing
Lap-Belt Installation
•
Figure A illustrates a typical forward-facing, lap-
belt installation.
•
When not in use, always store the LCS connectors
in the storage slots. See page 29.
WARNING!
•
This child seat must NOT be used forward-
facing for children less than one year of age
OR who weigh less than 9.1 kg (20 lbs).
•
This child seat must be in the upright position
when installed forward-facing.
•
Always use the Versa-Tether when the child
seat is installed forward-facing. Check your
vehicle owner's manual for approved tether
anchor locations.
1
Place the child seat forward-facing on the vehicle
seat. Ensure the bottom of the child seat base is in
full contact with the vehicle seat.
2
Remove the Versa-Tether from the pouch and
place it up and over the child seat back.
3
Pull the vehicle belt out, then pass it through the
forward-facing belt path to the opposite side of
the child seat (Fig. B).
4
Verify that the vehicle belt is not twisted, then buckle (Fig. C).
5
Push the child seat firmly into vehicle seat while removing slack from
the vehicle belt.
6
Attach the Versa-Tether
chosen seating position. Remove all the slack from the tether to secure.
Store any excess webbing in the tether pouch. See pages 25 – 27.
22
hook to the designated tether anchor for the
®
A
Forward-Facing
b
C
Advertisement
Table of Contents
