Jumper Settings - MSI 611BF User Manual

2. Install the CPU
3. Install DRAM Modules
4. Install Expansion card
5. Connect Cables, Wires, and Power Supply

2-5 Jumper Settings

1. CPU Bus Frequency Selection : JP1
※
Users can also set the CPU Bus frequency and CPU ratio under "Frequency / Voltage Control
"of BIOS SETUP.
Table for the Socket370 Cpu
CPU Type
Celeron-300/300A
Celeron-333
Celeron-366
Celeron-400
Celeron-433
Celeron-466
※
Before install CPU please check the CPU Sepecification , and setting the correct CPU Bus
Frequency (Front Side Bus) and ratio in the "CHIPSET FEATURES SETUP" of BIOS
SETUP.
2. CMOS RAM Clear: JP13 (Yellow color selector)
WARNING: Make sure your computer is POWER OFF when you CLEAR CMOS.
Connect a jumper Cap over this jumper for a few seconds, will clears information stored in
the CMOS RAM Chip that input by user, such as hard disk information and passwords.
After CLEAR CMOS, you must enter the BIOS setup (by holding down <DEL> during
power-up) to re-enter BIOS information (see BIOS SETUP).
Selections
Normal
Clear CMOS
JP13
1-2 Default for R.T.C.
2-3 Reset R.T.C.
CPU Clock Ratio
66 MHz 4.5X
66 MHz 5.0X
66 MHz 5.5X
66 MHz 6.0X
66 MHz 6.5X
66 MHz 7.0X
6
CPU Frequency
300 MHz
333 MHz
366 MHz
400 MHz
433 MHz
466 MHz