Table of Contents
Advertisement
Connect cable, wires &
power supplies
Bios Configuration
Clear CMOS
Bios Setup
Driver Installation
Intel810 inf files
Refer to page 4 Fig. 2-1 to identify Pin No.1 connector on the
Pg.
10-14
motherboard. (Black dot indicates Pin No.1).
Red line on the ribbon cable indicates Pin No.1.
Pg. 6
Short Pin 2-3 for 3 to 5 seconds on JP13 to clear CMOS.
1. Turn on the computer.
Pg. 6
2. Hold
the computer.
3. Main Menu on Display (Pg. 15 Fig 3-1)
4. Select 'Standard CMOS Feature' and
5. Check and adjust date, time and Drive A/B configuration.
*We suggest you do not change the default setting unless
you are very well informed about all detail of the BIOS.
Quick Installation Guide
After you have successfully loaded Windows 95/98 in to
your hard drive, enter into Windows 95/98.
1. From Windows 95/98.
Start
Intel810
2. Restart your computer.
3. Now windows will automatically load the following
drivers for Intel810.
Intel® firmware 82802 firmware hub device.
--Windows will automatically find driver if not specify.
Intel® 82801AA LPC Controller.
--Driver is in Windows95/98 CD.
Intel® 82801AA Ultra ATA Controller.
--Driver is under "C:\Windows\catroot."(only Windows98)
USB Root Hub.
Del
Down key immediately after turning on
Run
infinst
44
Enter
Insert Driver CD
Setup
press.
Browse
Advertisement
Table of Contents
