Table of Contents
Advertisement
Push the reset button. The earth leakage indicator turns OFF subsequently.
6
Turn (Push-down) the circuit breaker (lever) to OFF position.
7
In the event you cannot complete every step of the above procedure to the end,the
device is out of order. Consult with our authorized distributor or our engineering section
and ask to repair.
(3) Earth leakage Relay has activated
If the earth leakage breaker relay has been activated, the earth leakage indicator turns
ON, and the breaker (lever) is tripped and positioned in the middle between ON and
OFF.
When this occurs, stop the engine and repair the location of earth leakage before
restarting operation. (In the case the earth leakage indicating lamp does not turn to ON
simultaneously, the cause is Over-Loaded.)
8. Pre-Operation Inspection
WARNING : ELECTRIC SHOCK/INJURY
Always turn the Power Switch to the OFF position and stop the engine, then
close and lock OPERATION PANEL DOOR before checking or maintaining
the engine or any equipment.
Do not open the check door when the Power Switch is in the ON position. It
will cause injury by rotating parts such as cooling fans and fan belt.
CAUTION : BURNS
Do not touch the engine and surrounding components immediately after
stopping the engine as they are still extremely hot.
CAUTION : FIRE
Always be sure to wipe up any spilled fuel or oil.
8-1. Checking Engine Oil
To check the engine oil, keep the equipment in leveled position, remove the oil level
gauge and wipe so that no oil remains, and then re-insert the dipstick fully. Prior to
starting the engine, make sure to fill the engine oil through the oil filler until it reaches
the MAX line.
< Note >
Wait approximately five minutes
or more after stopping the
engine or adding oil before
checking the oil level again.
An accurate oil level reading
cannot be obtained if the
generator is not placed in
leveled position.
Do not overfill with oil to avoid
engine damage.
(1) Types of Engine Oil
Use only API service-type CF class.
Oil Filler
Oil Level
Gauge
22
Oil Level
MIN
MAX
Gauge
Not
Too
OK
Enough
Much
Advertisement
Table of Contents
