JVC MX-GA9V Service Manual page 23

Compact component system
Hide thumbs Also See for MX-GA9V:
Table of Contents

Advertisement

3.3.8 Removing the actuator motor and belt
(See Fig.18~21)
(1) Remove the two screws I retaining the gear bracket.
(2) While pressing the pawl t fixing the gear bracket in the ar-
row direction, remove the gear bracket.
(3) From the notch u section on the chassis assembly fixing
the edge of gear bracket, remove and take out the gear
bracket.
(4) Remove the belts respectively from the right and left actu-
ator motor pulleys and pulley gears.
(5) After turning over the chassis assembly, remove the actu-
ator motor while spreading the four pawls v fixing the right
and left actuator motors in the arrow direction.
ATTENTION:
When the chassis assembly is turned over under the condi-
tions wherein the gear bracket and belt have been removed,
then the pulley gear as well as the gear, etc. constituting the
gear unit can possibly be separated to pieces. In such a case,
assemble these parts by referring to the assembly and config-
uration diagram in Fig. 21.
Gear bracket
Pulley gear
Belt
I
Motor pulley
All manuals and user guides at all-guides.com
Pulley gear
Belt
Motor pulley
I
t
Pawl
Fig.18
Assembly and Configuration Diagram
Pulley gear
Gear B
Gear C
Select gear
Chassis assembly
v
Pulley gear
Gear B
Gross gear U
Gear C
Gross gear L
Fig.21
u
Gear bracket
Fig.19
Actuator motor
Fig.20
Cylinder gear
(No.MB011)1-23
v

Advertisement

Table of Contents
loading

Table of Contents