Table of Contents
Advertisement
3.3.6 Removing the try select switch board
(See Fig.14)
(1) Remove the two screws G retaining the tray select switch
board.
(2) Disconnect the tray select switch board from connector
CN854
on the CD servo control board.
3.3.7 Removing the cam unit
(See Fig.15 ~17)
• Remove the CD loading mechanism assembly.
(1) While turning the cam gear q , align the Paul r position of
the drive unit to the notch position on the cam gear q .
(2) Pull out the drive unit and cylinder gear .
(3) While turning the cam gear q , align the Paul s position
of the select lever to the notch position on the cam gear q .
(4) Remove the four screws H retaining the cam unit(cam
gear q and cams R1/R2 assembly).
Drive unit
r
1-22 (No.MB011)
All manuals and user guides at all-guides.com
q
Cam gear
Fig.15
Chassis assembly
CN854
CN851
CD servo
control board
Fig.14
Fig.16
H
Cams R1, R2 assembly
q
Cam gear
s
Select lever
Fig.17
Tray select
switch board
G
CN804
Drive unit
Cylinder gear
Cam unit
H
Advertisement
Table of Contents
