Table of Contents
Advertisement
3.1.9 Removing the power board
(See Fig.20)
• Prior to performing the following procedure, remove the metal
cover, the CD changer mechanism assembly and the rear pan-
el.
(1) Remove a wire clamp on the power board.
(2) Disconnect the wire from connector CN218,
CN250
on the power board.
(3) Disconnect connector
regulator board.
3.1.10 Removing the amplifier board / voltage board / heat sink
(See Fig.21, 22)
• Prior to performing the following procedure, remove the metal
cover, the CD changer mechanism assembly and the rear pan-
el.
(1) Disconnect the wires from connector CN703,
CN706
on the amplifier board respectively.
(2) Remove the two wire clamps attaching the wire to the am-
plifier board and the voltage board.
(3) Disconnect connector
CN216
on the voltage board from the regulator board (The
heat sink will be detached at once).
(4) Remove the four screws J attaching the amplifier board to
the heat sink.
(5) Remove the two screws K, the board bracket and the volt-
age board.
REFERENCE:
It is not necessary to remove the power board.
1-12 (No.MB011)
All manuals and user guides at all-guides.com
CN219
CN213
on the power board from the
CN704
CN215
on the amplifier board and
Power board
CN219
and
CN250
CN213
Amplifier board
CN704
CN706
and
Wire clamp
Voltage board
Regulator board
Heat sink
Voltage board
K
CN218
Wire clamp
Fig.20
Wire clamp
CN215
CN216
Fig.21
Amplifier board
Fig.22
CN703
J
J
Advertisement
Table of Contents
