JVC MX-GA9V Service Manual page 19

3.3.2 Removing the CD tray assembly
(See Fig.2~9)
(1) Remove the CD servo control board.
(2) Remove the screw B retaining the lod stopper.
(3) From the T.bracket section b and clamper base section c ,
remove both of the edges fixing the rod.
(4) Remove the three screws C retaining the T.bracket.
(5) Remove the screw D retaining the clamper assembly.
(6) From the left side face of the chassis assembly, remove the
one screw E retaining both of the return spring and lock le-
ver.
(7) By removing the pawl at the section d fixing the return
spring, dismount the return spring.
(8) Remove the three lock levers.
(9) Check whether the lifter unit stopper has been caught into
the hole at the section e of CD tray assembly as shown in
Fig.5.
(10) Make sure that the driver unit elevator is positioned as
shown in Fig.6 from to the second or fifth hole on the left
side face of the CD changer mechanism assembly.
CAUTION:
In case the driver unit elevator is not at above position,
set the elevator to the position as shown in Fig.7 by man-
ually turning the pulley gear as shown in Fig.8.
(11) Manually turn the motor pulley in the clockwise direction
until the lifter unit stopper is lowered from the section e of
CD tray assembly.
(12) Pull out all of the three stages of CD tray assembly in the
arrow direction f until these stages stop.
(13) At the position where the CD tray assembly has stopped,
pull out the CD tray assembly while pressing the two pawls
g and g' on the back side of CD tray assembly. In this
case, it is easy to pull out the assembly when it is pulled out
first from the stage CD tray assembly.
b
Rod
T.Braket
All manuals and user guides at all-guides.com
Clamper base
c
Fig.2
C
Clamper assembly
Fig.3
Lock lever
Fig.4
Fig.5
T.Braket
C
B
Lod stopper
(C/J version only)
C
D
d
Return spring
E
Stopper
e
CD tray
assembly
(No.MB011)1-19