Table of Contents
Advertisement
3.1.12 Removing the regulator board
(See Fig.25)
• Prior to performing the following procedure, remove metal cov-
er, CD changer mechanism assembly, rear panel, antenna
board, main board, amplifier board, voltage board, power
board and speaker board.
(1) Disconnect the wire from connector
tor board.
(2) Release the wire from the stopper on the regulator board.
(3) Remove the two screws M attaching the reglator board.
3.1.13 Removing the power cord
(See Fig.26)
• Prior to performing the following procedure, remove the metal
cover, the CD changer mechanism assembly and the rear pan-
el.
(1) Disconnect the wire from connector
board.
(2) Remove the wire clamp from the power board.
(3) Move the power cord stopper upward and pull out it from
the base chassis.
1-14 (No.MB011)
All manuals and user guides at all-guides.com
CN204
on the regula-
CN250
on the power
M
Power transformer assembly
Fig.25
Power board
CN250
Power cord stopper
Base chassis
Fig.26
Stopper
M
Regulator board
CN204
Wire clamp
Advertisement
Table of Contents
