Table of Contents
Advertisement
AWARD BIOS
Integrated Peripherals à Onboard Serial Port 1
Integrated Peripherals à Onboard Serial Port 2
Onboard Serial Port 1
This item allow you to assign address and interrupt
for the board serial port. Default is Auto .
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Note: If you are using an network card, make
sure that the interrupt does not conflict.
Integrated Peripherals à Onboard UART 2 Mode
Onboard UART 2
Mode
Standard
HPSIR
ASKIR
•
-
Standard
Sets serial port 2 to operate in normal mode. This is the
default setting.
•
-
HPSIR
Select this setting if you installed an Infrared module in your
system via IrDA connector (refer to section 2.3 "Connectors").
setting allows infrared serial communication at a maximum baud rate of
115K baud.
•
-
ASKIR
Select this setting if you installed an Infrared module via IrDA
connector (refer to section 2.3 "Connectors"). This setting allows infrared
serial communication at a maximum baud rate of 19.2K baud.
3-32
This item is configurable only if the "Onboard UART
2" is enabled. This allows you to specify the mode
of serial port2. The available mode selections are:
This
Advertisement
Table of Contents
