Table of Contents
Advertisement
AWARD BIOS
Integrated Peripherals à IDE Primary Master PIO
Integrated Peripherals à IDE Primary Slave PIO
Integrated Peripherals à IDE Secondary Master PIO
Integrated Peripherals à IDE Secondary Slave PIO
IDE Primary Master
Setting this item to
PIO
auto-detect function.
Auto
data transfer rate of HDD. For example: mode 0
data transfer rate is 3.3MB/s, mode 1 is 5.2MB/s,
Mode 1
mode 2 is 8.3MB/s, mode 3 is 11.1MB/s and mode 4
Mode 2
is 16.6MB/s. If your hard disk performance becomes
Mode 3
unstable, you may manually try the slower mode.
Mode 4
Caution:
connect the first IDE device of each
channel to the endmost connector of the
IDE
"Connectors" for details on how to connect
IDE device(s).
Integrated Peripherals à IDE Primary Master UDMA
Integrated Peripherals à IDE Primary Slave UDMA
Integrated Peripherals à IDE Secondary Master UDMA
Integrated Peripherals à IDE Secondary Slave UDMA
IDE Primary Master
This item allows you to set the Ultra DMA/33 mode
UDMA
supported by the hard disk drive connected to your
primary IDE connector.
Auto
Disabled
Integrated Peripherals à On-Chip Primary PCI IDE
Integrated Peripherals à On-Chip Secondary PCI IDE
On-Chip Primary
This parameter lets you enable or disable the IDE
PCI IDE
device connected to the primary IDE connector.
Enabled
Disabled
3-30
Auto
activates the HDD speed
The PIO mode specifies the
It is recommended that you
cable.
Refer
to
section
2.3
Advertisement
Table of Contents
