Adjusting The Shock Sensor; Testing The Shock Sensor; Dome Light Delay / Theater Dimming - Code Alarm PROFESSIONAL Series Installation Manual

Adjusting the Shock Sensor

1. Increase sensitivity by turning the adjustment dial clockwise.
2. Decrease sensitivity by turning the adjustment dial counter clockwise.

Testing the Shock Sensor

Arm the system and wait 6 seconds for the zone to stabilize, then firmly strike the
vehicles bumper.

Dome Light Delay / Theater Dimming

When the Dome Light Delay is set to "Program Custom Time" in feature
programming (this is the default setting)
arming after the lock button is pressed for vehicles with a dome light delay or theater
dimming feature. Once programed the system will 'learn' the timing of the dome light
delay (60 second max) and add 2 seconds before arming.
1. Close all doors with ignition off.
2. Using the transmitter press LOCK, UNLOCK, LOCK ,UNLOCK, LOCK ,
UNLOCK, LOCK. The LED will light solid to indicate the system has
entered DOME DELAY LEARN MODE.
3. Immediately OPEN then CLOSE the door WITHOUT disarming the
system. The system will then monitor the door trigger wire. Once the
dome light turns off, the system will then add 2 seconds and then exit
the learning mode.
4. The LED will begin to flash indicating the system has exited the
learning mode and is now armed.
Note: To program a custom delay time Feature Bank 2, Feature 16, "Dome Light
Delay: Preset Time or Programmable, must be set to "OFF/Program Custom Time".
Defaulting the Dome Light Delay: Turn the ignition ON then OFF 3 times then
press and hold the valet button for 5 seconds, the system will chirp 1 time indicating
the learned delay time has been cleared.
16
t
he system can be programed to delay
ca1155 rev B