Shock Sensor - Code Alarm professional series PROCOMP Installation Manual

Professional series security and remote start
Table of Contents

Advertisement

Shock Sensor

Adjusting the impact sensitivity of the shock sensor.
1. Increase sensitivity by turning the adjustment dial clockwise.
2. Decrease sensitivity by turning the adjustment dial counter clockwise.
Testing the sensitivity of the shock sensor.
Arm the system and wait 6 seconds for the zone to stabilize, then firmly strike the
vehicles bumper.
Bypassing The Shock Sensor.
There are 3 additional modes of operation in which your system will react to the
shock sensor, FULL TRIGGER ONLY, ALL OFF, or CITY MODE.
Press LOCK once to arm the system.
Pressing LOCK again within 2 seconds will set the system to FULL TRIGGER
ONLY in which the system will ignore the light touch setting.
Pressing LOCK again within 2 seconds will set the system to ALL OFF. In this
mode the system will not react to the shock sensor and the 2-way LCD remote will
display the shock sensor icon.
Pressing LOCK again within 2 seconds will set the system to CITY MODE. In this
mode the light touch horn output is extended to a full 10 seconds and full trigger
horn output is shortened to 15 seconds, no icon is displayed.
NOTE: The system will only change the shock sensor setting for one arm cycle and
will be defaulted back to normal operation the next time the system is armed.
Programmable Wait-To-Start Option
Select the Programmable Delay option for the Gas/Diesel feature, once selecting
this option, ground the wait-to-start input between 1 and 60 seconds. This will
program the delay for the period of time the input was grounded with a min of 1
second and a max of 60 seconds.
32
2012 Audiovox Electronics Corporation. All rights reserved.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procomp

Table of Contents