Code Alarm Professional Series Owner's Manual
Hide thumbs
Also See for Professional Series:
- Installation manual (24 pages) ,
- Owner's manual (12 pages) ,
- Installation quick reference manual (2 pages)
Advertisement
Quick Links
PROFESSIONAL
SERIES
Owner's Guide
For Model:
CA1BTW5
AS9234E
RF Upgrade Kit
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is
applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR
SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information.
CA1BTW5 / AS9234E 4280848 Owners rev A.
1
Advertisement
Related Manuals for Code Alarm Professional Series
Summary of Contents for Code Alarm Professional Series
- Page 1 PROFESSIONAL SERIES Owner’s Guide For Model: CA1BTW5 AS9234E RF Upgrade Kit IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply.
- Page 2 Table of Contents Using Your Remote Control ............3 2 Way Remote Control Notifications .........6 Transmitter Programming ............6 Replacing Remote Control Batteries ........7 2017 Voxx Electronics Corporation. All rights reserved.
-
Page 3: Using Your Remote Control
Flashlogic Functionality Using Your Remote Control Remote Starting Your Vehicle To activate the remote start, press and release the button 2 times within 2 seconds. The vehicle will start and run the predetermined time set up during installation (5 to 60 minutes selectable). Remote Start Shutdown To cancel the remote vehicle start function, press and release the button 2 times... - Page 4 Using the “Quick-stop” Feature With vehicle running, if you wish to make a quick stop and leave the vehicle running, once you arrive at your destination: a) place the gear selector in Park, b) set the parking brake, c) with your foot off the brake, press the transmitter button two times in succession.
- Page 5 Timed Start Operation: To begin the start timer, within 10 seconds of turning off the ignition switch, activate the RF command to start 2 times. (Press the start button four times). The lights will flash and the siren will chirp 4 times. Indicating timed interval mode has been initiated.
-
Page 6: 2 Way Remote Control Notifications
2 Way Remote Control Notifications FUNCTION BEEPS / LED FLASHES Activation 1 Beep / Flash Confirm Remote Start 4 Beeps / Flashes (repeats 3 times) Remote Start Running 1 Flash per 3 seconds for duration run time Remote Start Shutdown 3 Long Beep / Long Flashes (repeats 3 times) Low Battery 2 Beeps / Flashes when button is pressed... -
Page 7: Replacing Remote Control Batteries
Replacing Remote Control Batteries 1 Way Remote Control, CAT1: The battery (model CR2032) inside each remote control should last approximately 1 year under normal use. When the battery becomes weak you will notice the remote control range (the distance from the vehicle the remote control will work) deteriorate and the small LED on the remote control will dim. - Page 8 Voxx Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.