Page 1
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may not apply. Please see your installing dealer for more information. CA1B6 / FLRS 4280922 Owners rev A.
Page 2
Table of Contents Using Your Remote Control ............3 Remote Start Valet Mode ............3 Transmitter Programming ............4 Replacing Remote Control Batteries ........4 2018 Voxx Electronics Corporation. All rights reserved.
Valet Mode Programming Procedure completed. NOTE: In Valet Mode, the remote starter is not functional. On units with keyless entry, lock and unlock will remain functional. To exit valet mode: repeat steps 1 to 4. CA1B6 / FLRS 4280922 Owners rev A.
Transmitter Programming Turn the ignition ON. Press and hold the valet/override button located on the antenna. Within 10 seconds the LED’s will begin to flash. Press 1 button of each transmitter you wish to program, the LED’s will flash to confirm each transmitter. Turn the ignition OFF NOTE: This system has 1 button programming which programs all channels of the system.
Voxx Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.