Telephone Base & Charger Installation - AT&T CL82200 User Manual

Getting started
Telephone base & charger installation
Install the charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see for details.
2. Route the power adapter cord through the slot.
6 Plug the other end
of the telephone
line cord into a
telephone jack or
a DSL filter.
Charger installation
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
2. The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
Telephone line cord
If you have DSL high
speed Internet service,
a DSL filter (not
included) is required.
Plug the power adapter into an
electrical outlet not controlled
by a wall switch.
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
5
Power
adapter
1. Plug one end of the
telephone line cord
into the telephone jack
on the bottom of the
telephone base.
3. Plug the small end of
the telephone base
power adapter into
the telephone jack
on the bottom of the
telephone base.
4. Place the cords into
the channels.
5. Plug the large end
of the power adapter
into a power outlet
not controlled by a
wall switch.
7. Raise the antenna.
or call
.