Remote Access Code; Message Alert Tone - AT&T CL82200 User Manual

Handset settings
Answering system settings

Remote access code

To access your answering system remotely from any touch tone
phone, you need to enter a two-digit number (10-99). Unless
you change it, the remote access code is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press CID or
/SELECT.
MENU
3. Press CID or
/SELECT.
MENU
4. Press CID or
/SELECT.
MENU
5. Use the dial pad to enter a
to backspace and delete a digit, or press
change the remote access code.
6. Press /SELECT to confirm your setting and you hear a
MENU
confirmation tone. Press

Message alert tone

When the message alert tone is set to ON, and there is at least one new
message, the telephone base beeps every 10 seconds.
you change it, the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/
enter the main menu.
2. Press CID or
/SELECT.
MENU
3. Press CID or
/SELECT.
MENU
4. Press CID or
/SELECT.
MENU
5. Press CID or
6. Press /SELECT to confirm your setting and you hear a
MENU
confirmation tone. Press
DIR to scroll to >Answering sys, then press
DIR to scroll to >Ans sys setup, then press
DIR to scroll to >Remote code, then press
four-digit number. Use
OFF/
CLEAR
DIR to scroll to >Answering sys, then press
DIR to scroll to >Ans sys setup, then press
DIR to scroll to >Msg alert tone, then press
DIR to choose between On and Off.
OFF/
CLEAR
SELECT
MUTE
CID or
to cancel the procedure.
SELECT
to cancel the procedure.
19 19
Play messages
Answering sys
>
to
Ans sys setup
>
--End of list--
Remote code
>
Msg alert tone
/DELETE
DIR to
REMOTE CODE
Unless
Play messages
Answering sys
>
to
Ans sys setup
>
--End of list--
Msg alert tone
>
Call screening
MSG ALERT TONE
>On
19