Telephone Base Installation - AT&T E2562 User Manual

ATT-2562CIB-d4.qxd 12/29/2003
Getting Started
Telephone base installation (2-line jack)
If you have a 2-line jack, install the base as shown below. Choose a location away
from electronic equipment, such as personal computers, television sets or microwave
ovens. Avoid excessive heat, cold, dust or moisture.
Line 1 + Line 2
Connect the black line cord to jack
labeled LINE1/L1+L2
Line identification
To identify phone lines, press
then call one of your telephone numbers. If you
hear a busy signal, Line 1 is the number you
called. If Line 2 rings, it is the number you called.
6:20 PM Page 6
Plug base power
cord transformer
into electrical outlet
,
SPEAKERPHONE
6
Connect handset cord
to corded handset
NOTE: Use only the power
cord supplied with this product.
If you need a replacement, call
1 800 222–3111.
Be sure to use an electrical outlet
not controlled by a wall switch.