System Connections; Wr (Weatherised) Models Only - Martin Audio CDD Series User Manual

CDD USER GUIDE

SYSTEM CONNECTIONS

All CDD Series and CSX Series speakers are fitted with low-profile four-pin push-lock connectors, rated at 13 A (CDD5, CDD6 and
CDD8) or 20 A (CDD10, CDD12, CDD15 and all CSX models). These are mounted on the recessed rear panel, allowing for a very
neat wiring job with no protruding connectors.
To permit simple interconnection between multiple speaker cabinets on the same circuit, two of the pins are designated as 'Link'
connections; these can be used to "daisy-chain" the amplifier output to the next speaker:
A mating connector is supplied with each cabinet. In a fixed installation, this can be fitted to the speaker cables during first fix.

WR (WEATHERISED) MODELS ONLY

On Models CDD5TX-WR and CDD6TX-WR the gland is positioned for vertical cable entry; there is a second hole fitted with a
"knock-out" to the right to allow a second gland (not supplied) to be fitted if cabinets are to be daisy-chained. On Models CDD8-
WR and above, a single cable gland is positioned for rearwards cable entry.
The cover is retained in place by two (CDD8-WR and above) or three (CDD5/6TX-WR) hex-head screws: remove these to remove
the cover, taking care not to damage the gasket which seals the cover against the rear panel. Loosen the gland's cable clamp nut
and pass the cable through the gland assembly and then connect to the INPUT terminals as described above. In the case of the
CDD5TX-WR or CDD6TX-WR, if daisy-chaining to another speaker, remove the knock-out, fit a second gland and repeat the
process, connecting the second cable to the LINK terminals.
CDD User Guide V1.0 43