VMCS HEAVY DUTY ELECTRIC GRIDDLE TOP - REMOVAL AND REPLACEMENT OF PARTS
ARM MECHANISM
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove springs from rear housing to release
system tension as outlined under REMOVE
CLAMSHELL FROM FRAME.
2.
Remove TOP CONTROL BOX COVER.
3.
If removing left arm:
A.
Note locations and disconnect power supply
wires from terminal strip.
Fig. 35
B.
Fully raise clamshell to access the left arm
wireway cover on the bottom of arm.
Remove wireway cover (1, Fig. 36) from the
bottom of left arm.
F45571 (0316)
Disconnect the
Page 12 of 19
Fig. 36
C.
Lower clamshell.
D.
Feed the power supply wires back into the
arm enough to clear the control box.
Fig. 37
4.
Remove 2 screws on the outer side of the arm
being replaced. The screws and locknuts secure
the control box to the arm and the control box
mounting shelf inside the box.