Table of Contents
Advertisement
Figure 26 Menu: AP Mode
The following table describes the sub-menus.
Table 13 Menu: AP Mode
LINK
Network
Wireless LAN
LAN
Maintenance
System
Logs
Tools
Sys OP Mode
Language
4.4 Setting your NBG-418N v2 to Universal Repeater Mode
Connect your computer to the LAN port of the NBG-418N v2.
1
Chapter 4 Modes
TAB
FUNCTION
General
Use this screen to configure wireless LAN.
MAC Filter
Use the MAC filter screen to configure the NBG-418N v2 to block access
to devices or block the devices from accessing the NBG-418N v2.
Advanced
This screen allows you to configure advanced wireless settings.
WPS
Use this screen to configure WPS.
WPS Station
Use this screen to add a wireless station using WPS.
Scheduling
Use this screen to schedule the times the Wireless LAN is enabled.
MBSSID
Use this screen to set the SSID for wireless AP.
IP
Use this screen to configure LAN IP address and subnet mask.
General
Use this screen to view and change administrative settings such as
system and domain names, password and inactivity timer.
Time Setting
Use this screen to change your NBG-418N v2's time and date.
View Log
Use this screen to view the logs for the categories that you selected.
Firmware
Use this screen to upload firmware to your NBG-418N v2.
Configuration
Use this screen to backup and restore the configuration or reset the
factory defaults to your NBG-418N v2.
Restart
This screen allows you to reboot the NBG-418N v2 without turning the
power off.
General
This screen allows you to select the device operation mode: Router,
Access Point, or Universal Repeater.
Language
This screen allows you to select the language you prefer.
NBG-418N v2 User's Guide
39
Advertisement
Table of Contents
