Table of Contents
Advertisement
You will lose all of your changes when you push the WPS/RESET button.
To reset the NBG-418N v2,
Make sure the power LED is on.
1
Press the WPS/RESET button for longer than 10 second to reboot and restore factory-default
2
configurations on the NBG-418N v2.
If the NBG-418N v2 restarts automatically, wait for the NBG-418N v2 to finish restarting, and log in
to the Web Configurator. The username is admin and password is 1234.
If the NBG-418N v2 does not restart automatically, disconnect and reconnect the NBG-418N v2's
power. Then, follow the directions above again.
21.5 Wireless Problems
I cannot access the NBG-418N v2 or ping any computer from the WLAN.
Make sure the wireless LAN is enabled on the NBG-418N v2.
1
Make sure the wireless adapter on the wireless station is working properly.
2
Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports
3
the same wireless standard as the NBG-418N v2.
Make sure your computer (with a wireless adapter installed) is within the transmission range of the
4
NBG-418N v2.
Check that both the NBG-418N v2 and your wireless station are using the same wireless and
5
wireless security settings.
Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the NBG-418N
6
v2.
Make sure you allow the NBG-418N v2 to be remotely accessed through the WLAN interface. Check
7
your remote management settings.
• See
Chapter 6 Wireless LAN
I cannot access the Web Configurator after I switched to a non-router mode.
Chapter 21 Troubleshooting
for more information.
NBG-418N v2 User's Guide
146
Advertisement
Table of Contents
