Table of Contents
Advertisement
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
2
Start Guide.
Make sure your Internet browser does not block pop-up windows and has JavaScript and Java
3
enabled. See
Make sure your computer is in the same subnet as the NBG-418N v2. (If you know that there are
4
routers between your computer and the NBG-418N v2, skip this step.)
• If there is a DHCP server on your network, make sure your computer is using a dynamic IP
address.
• If there is no DHCP server on your network, make sure your computer's IP address is in the
same subnet as the NBG-418N v2.
Reset the device to its factory defaults, and try to access the NBG-418N v2 with the default IP
5
address.
If the problem continues, contact the network administrator or vendor, or try one of the advanced
6
suggestions.
Advanced Suggestions
• If your computer is connected to the WAN port or is connected wirelessly, use a computer that is
connected to a LAN/ETHERNET port.
I can see the Login screen, but I cannot log in to the NBG-418N v2.
Make sure you have entered the password correctly. The default username is admin and default
1
password is 1234. This field is case-sensitive, so make sure [Caps Lock] is not on.
This can happen when you fail to log out properly from your last session. Try logging in again after
2
5 minutes.
Disconnect and re-connect the power adaptor or cord to the NBG-418N v2.
3
If this does not work, you have to reset the device to its factory defaults. See
4
145.
21.3 Internet Access
I cannot access the Internet.
Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
1
Start Guide.
Chapter 21 Troubleshooting
Appendix B on page
158.
NBG-418N v2 User's Guide
144
Section 21.4 on page
Advertisement
Table of Contents
