Enable And Configure Wireless Security Without Wps On Your Nbg-417N - ZyXEL Communications NBG-417N - V1.0 Manual

6.3 Enable and Configure Wireless Security
without WPS on your NBG-417N
This example shows you how to configure wireless security settings with the
following parameters on your NBG-417N.
SSID
Channel
Security
Follow the steps below to configure the wireless settings on your NBG-417N.
The instructions require that your hardware is connected (see the Quick Start
Guide) and you are logged into the Web Configurator through your LAN connection
(see Section 3.2 on page
Open the Wireless LAN > General screen in the AP's Web Configurator.
1
Make sure the Enable Wireless LAN check box is selected.
2
Enter SSID_Example3 as the SSID and select a channel.
3
Set security mode to WPA-PSK and enter ThisismyWPA-PSKpre-sharedkey in
4
the Pre-Shared Key field. Click Apply.
Figure 31 Tutorial: Network > Wireless LAN > General
NBG-417N User's Guide
SSID_Example3
6
WPA-PSK
(Pre-Shared Key: ThisismyWPA-PSKpre-sharedkey)
27).
Chapter 6 Tutorials
65