Removing The Mounting Stand Cover Set; Removing The Stand Cover Set - IBM 4836 Planning, Installation And Service Manual

Removing the mounting stand cover set

To remove the cover set for the table-top mounting stand, follow these steps:
Figure 32. Removing the stand cover set
1. Remove the arm cover ( B ) by pulling on the finger recess ( A in Figure 32)
2. Remove the base cover ( C ) by pulling the cover away from the display.
3. Snap out the cable shield.
4. To remove the plastic base housing, unfasten the four screws.
located on the top of the cover.
Note: Extra pressure may be necessary.
Chapter 4. Removing and replacing FRUs
45