Removing The Lcd - IBM 4836 Planning, Installation And Service Manual

Removing the LCD

1. Remove the covers as described in "Removing the back cover" on page 28.
Figure 29. Removing the LCD
2. Remove the eight screws ( A ) holding the system board (main planar) and
3. Disconnect the following cables and connectors:
4. Remove the LCD assembly (includes system board).
5. Turn the LCD assembly over to locate and remove the four screws holding the
6. Disconnect the main signal cable from the back of the LCD.
42
Anyplace Kiosk 4836
B
LCD assembly to the front bezel.
Note: You do not need to remove the system board from the LCD assembly to
remove the LCD.
v Touch cable (see A in Figure 27 on page 40)
v Speakers (see B in Figure 24 on page 37)
v Control card cable (see B in Figure 27 on page 40)
v LCD backlight connectors (2) (see A in Figure 28 on page 41)
Note: Take care not to bend the metal antenna ( B in Figure 29).
LCD to the back of the LCD assembly. Remove the LCD.
A