Removing The Front Panel Card - IBM 4836 Planning, Installation And Service Manual

Removing the front panel card

1. Remove the back cover as described in "Removing the back cover" on page 28.
2. Remove the system board assembly as described in "Removing the system
Figure 27. Removing the front panel card
3. See Figure 27. Disconnect the speaker connections from the card ( E ).
4. Remove the touch cable ( A ) as follows:
5. Remove the control card cable ( B ) by pulling it out from the card.
6. Unfasten the three screws ( C ) to remove the card.
7. To replace, locate the alignment pin ( D ) and hole and lower the front panel
8. Replace the three screws.
40
Anyplace Kiosk 4836
board" on page 38.
a. Locate the gray latches on either side of the cable.
b. Pull backward on the latches to release.
c. Slip the cable out of the slots.
card onto the pin.