Removing The Backlight Inverter Card - IBM 4836 Planning, Installation And Service Manual

Removing the backlight inverter card

1. Remove the back cover as described in "Removing the back cover" on page 28.
2. Disconnect and remove the hard drive fan as described in "Removing the hard
3. Remove the system board in "Removing the system board" on page 38.
A
Figure 28. Removing the backlight inverter card
4. See Figure 28. Disconnect the following from the card:
5. Remove the three screws ( C ) holding the backlight inverter card ( D ).
6. Lift upward to remove the card.
7. To replace, reverse these procedures.
drive fan" on page 33.
B
v Back light cables (2) ( A )
v Video cable ( B )
Note: The alignment pin and corresponding hole in the card assist you in
replacing the card.
C
Chapter 4. Removing and replacing FRUs
D
41