Replacing The Front Bezel - IBM 4836 Planning, Installation And Service Manual

Replacing the front bezel

1. Remove the cover as described in "Removing the back cover" on page 28.
Figure 31. Replacing the front bezel
2. Disconnect the touch cable ( A ) and control card cable ( B ).
3. Remove the control card C .
4. Disconnect the speakers ( D ) and lift to remove
5. Remove the eight screws ( E ) holding the LCD assembly (includes the system
6. Lift out the LCD assembly from the front bezel, being careful not to bend the
7. To replace the front bezel, reverse these procedures.
44
Anyplace Kiosk 4836
E
A
board) to the front bezel.
antenna.
B
D
C