Removing the processor
Note: See figure Figure 22 on page 35. Locate the processor ( C ) after you
To remove the processor, follow these steps:
1. Turn the screw holding the processor 180 degrees to release.
2. Lift out the processor, carefully keeping your fingers on each side of the module.
3. To replace, reverse these procedures.
Removing the hard disk drive and bracket
Follow these steps to remove the hard disk drive and bracket:
Figure 23. Removing the hard disk drive and bracket
1. Open the hard drive door ( A in Figure 23).
2. Remove the hard disk drive ( B ) by sliding the drive outward.
3. Remove the four screws ( C ) holding the hard disk drive bracket ( D ) and lift
4. To replace, locate the right and left side rails with the correct side of the rails
5. Replace the 4 screws.
6. Reinstall the hard disk drive and door.
36
Anyplace Kiosk 4836
remove the heat sink.
D
to remove.
upward.
B
C
A