Installing Table-Top Mount - IBM 4836 Planning, Installation And Service Manual

Table-top mount
Figure 10. Installing table-top mount
1. Remove the base cover ( A ) and arm cover ( B ).
2. Route and connect the cables ( C ) to the IBM 4836.
3. Close cable cover and tighten thumbscrew ( D ) on the cover.
4. Close USB cover (optional).
5. Attach the mount to the unit with the four screws.
6. Install the base cover ( A ) and the arm cover ( B ).
7. Place the IBM 4836 unit in the desired location and retain the cables (see
Note: You can bolt the unit to the counter top, using the hole provided in the
Wall mount
Follow the procedures described in Chapter 3, "Mounting the IBM Anyplace Kiosk to
the wall," on page 17.
"Retaining the cables" on page 10).
mount.
Chapter 2. Installing the IBM Anyplace Kiosk
15